李姊桐,张庆国,邢小林.基于测井系列校正的趋势面分析法标准化研究[J].地质找矿论丛,2018,33(2):272-277
基于测井系列校正的趋势面分析法标准化研究
Normalization study of trend surface analysis based on logging series' correction
投稿时间:2017-01-05  
DOI:10.6053/j.issn.1001-1412.2018.02.014
中文关键词:  测井曲线  标准化  测井系列校正  趋势面分析法  构造等高线
英文关键词:well log curve  normalization, well logging series' correction, trend surface analysis method, structural contour maps
基金项目:
作者单位
李姊桐 大庆油田有限责任公司第二采油厂第五作业区, 黑龙江 大庆 163414 
张庆国 东北石油大学地球科学学院, 黑龙江 大庆 163318 
邢小林 大庆油田有限责任公司第四采油厂第四油矿, 黑龙江 大庆 163000 
摘要点击次数: 1168
全文下载次数: 1004
中文摘要:
      对测井资料进行标准化处理是地质精细解释的前提,不仅能提高测井资料的准确性,并且能保障测井解释精度。本文采用趋势面分析法对测井资料进行标准化。在进行第一次标准化处理时,由于研究区内新老井应用多种测井系列测量,出现了由测井系列差异引起的异常点。因此,将测井系列校正纳入标准化处理流程,即当工区开发历时较久、范围较大、测井系列较多时,在测井资料标准化之前必须先进行测井系列校正;提出了测井系列校正的方法,应用该方法对测井资料校正后,再进行第二次标准化处理。其结果检验表明,处理后的测井信息更加符合区域地质规律,证明该思路符合实际需求,能更加准确地完成区块测井资料的标准化,可以推广至全区及其它类似工区。
英文摘要:
      Logging data normalization is the premise of fine geological interpretation, which can not only improve the accuracy of logging data, but also can guarantee the accuracy of log interpretation. In this paper, trend surface analysis method is used for logging data normalization. During the first normalization, some outliers appeared due to different logging series used in the old and new wells. Therefore, this paper introduces the logging series' correction to the normalization process, i.e. for working areas which are in large area having a long exploitation history and multi-logging series were used the correction of logging series must be done before the normalization. This paper proposes a logging series' correction method. After logging data correction with this method begin the second normalization. Result of the normalization procession t shows that the processed logging information is more consistent with the law of the regional geological condition. Such normalization meets need of the actual situation and completes regional logging data normalization more accurately so it can be popularized to the whole region and other similar regions.
查看全文  查看/发表评论  下载PDF阅读器
关闭